Pulsar 3.2 Pro
F3J Sailplane 3,2 m span
Code 1.5
|
|
The three piece wing which is extremely light but very strong, is built with a Kevlar/carbon woven cloth D-box leading edge, with carbon capped ribs and a carbon trailing edge. This design is not afraid of heat and cold, is not afraid of moisture and rain. Wing and control surfaces are not subject to warping, as is usually the case with full balsa model counterparts. Central panel of the Pro model is made with a cross "V" 2 degrees, which improves the performance models, especially in small thermals. The control surfaces are pre-hinged with integral shrouds fitted to the flaps and ailerons making less drag. |
|
|
Specifications:
Wing span 3220 mm Length 1815 mm Wing Area 70,5 sq. dm Airfoil AG 25 mod. Weight (less R/C gear) 980 g
Control: Ailerons, Rudder, Elevator, Flaps. |
Equipment Installation Diagram. Recommended Equipment: Receiver battery 4 x 4/5 SC NiMh Servo 6 x 13 mm for elevator, rudder, ailerons, flaps. Recommended Control Travel: Elevator + / - 15 mm Rudder + /- 35 mm Flap Full down Ailerons + 10 mm/ - 6 mm Take off and landing + 8 mm/ - 4 mm Glide Use the template to set "0" flaps and ailerons. Available Pulsar 3.2 Pro with V-tail. Tape down all removable parts before flying! GOOD LUCK!
Download template.
