Pulsar 3.6 Pro


F3J Sailplane 3,6 m span

Code 1.7



The three piece wing which is extremely light but very strong, is built with a Kevlar/carbon woven cloth D-box leading edge, with carbon capped ribs and a carbon trailing edge.
This design is not afraid of heat and cold, is not afraid of moisture and rain. Wing and control surfaces are not subject to warping, as is usually the case with full balsa model counterparts.
The control surfaces are pre-hinged with integral shrouds fitted to the flaps and ailerons making less drag.

Central panel of the Pro model is made with a cross "V" 2 degrees, which improves the performance models, especially in small thermals.
The special shape of the fuselage is designed for precise landing and meets the requirements of the F3J FAI rules.
The fuselage is equipped with a ballast chamber for easy and rapid exchange of ballast in windy weather.





Wing span                   3630 mm

Length                        1815 mm

Wing Area                    80,5 sq. dm

Airfoil                          AG 25 mod.

Weight (less R/C gear)   1065 g


Control: Ailerons, Rudder, Elevator, Flaps.

Equipment Installation Diagram.



Recommended Equipment:


Receiver battery   4 x 4/5 SC NiMh

Servo                  6 x 13 mm elevator,

                      rudder, ailerons, flaps.

Recommended Control Travel:


Elevator      + / - 15 mm

Rudder        + /- 35 mm

Flap            Full down

Ailerons      + 10 mm/ - 6 mm Take off and landing

                 + 8 mm/ - 4 mm Glide

Use the template to set "0" flaps and ailerons.
Download template.

Available Pulsar 3.6 Pro with V-tail.




Tape down all removable parts before flying! 


You can write us: vitaliy300679@gmail.com